Digital SLR Electronic Flash Basic Tutorial
Introduction to the Physics of Flash Photography for Beginners
Dec 15, 2008
No matter what the brand or model of the flash unit (Canon, Nikon, Sony, Metz), all still follow the same laws of physics.
Flash and Camera Shutter Speed
Flash exposure is not affected by the camera shutter speed. This is because electronic flash lasts for about 1/10,000 seconds, faster than shutter speeds used for daily photography.
Whether the camera's shutter speed is 1/30 or 1/125 seconds, the amount of light from the flash reaching the camera's image sensor will be the same.
As the light from the flash still has to pass through the camera lens, the lens aperture will affect the amount of light from the flash that reaches the image sensor.
Mixing Flash and Ambient Light
By adjusting the shutter speed, it is possible to adjust the balance of flash versus ambient light (available light from the surroundings).
- Reducing the shutter speed will increase the amount of ambient light reaching the image sensor, with no effect on the amount of flash light
- Increasing the shutter speed will decrease the amount of ambient light reaching the image sensor, with no effect on the amount of flash light
Ambient light is good for brightening backgrounds, areas too far for the flash to reach. If the background in the photo is too dark, the shutter speed should be reduced.
Ambient light can cause problems with color balance. With incandescent (tungsten filament) light bulbs, photos will appear an unappealing yellow. Increasing the shutter speed will allow the whiter light from the flash to dominate, reducing the intensity of the yellow light in the photo.
Ambient light is also an issue when photographing subjects back-lit by the sun (sun is behind subject). "Fill-in flash" is used in this situation to lighten the shadows cast by the sun. High shutter speeds are used to help the flash compete with the sun's powerful light.
Maximum Flash Synchronization Speed
Due to mechanical focal-plane shutter limitations, DSLRs have a maximum flash synchronization speed. This is often 1/125, 1/200, 1/250 or 1/500 seconds. When the flash is switched on, the DSLR will not allow higher shutter speeds to be used. Otherwise, part of the photo will be blocked by the moving shutter and cause a black band to appear on the photo.
Inverse Square Law
Light intensity from the flash drops off quickly with distance. It follows an inverse square law. Compared to the light 5 feet away from the flash
- Light at 10 feet is 1/4 the brightness
- Light at 15 feet is 1/9 the brightness
- Light at 20 feet is 1/16 the brightness
Flash Range Limitations
Because of the inverse square law, flash range is limited. Indoor distances are small enough for flash to be practical. But for many outdoors situations, the flash unit will not be powerful enough.
Uneven Illumination Problems with Flash
The inverse square law also means that there can be uneven illumination across the photo.
With people at different distances (say, 5 and 10 feet), someone at 10 feet will need the total flash output to be four times brighter compared to the person at 5 feet. Either he will be under-exposed , or the person in front will be over-exposed.
One solution to this is to tilt the flash upwards and bounce the flash light off the ceiling. As both people are about the same distance from the ceiling, they will both receive the same amount of light.
This also creates softer, more pleasing shadows.
Flash Physics
Even with today's gee-whiz auto-everything computerized electronic flash units, photographers who understand the physics behind flash photography will be better able to make full use of their equipment.
